8' 6-Pin DIN cable for MPG-70, PG-200, PG-800 racks & hardware Each assign can control 5

Each assign can control 5 separate parameters

Gear mounted in the RETRAKT should not protrude beyond the back of the base

Modulation matrix lets users control any combination of MKS-80 parameters with any CC

Slope of the slewing is voltage controlled and can be varied between a classic RC glide and linear glide

Randomizer - Creates musically useful "randomized" tones at the press of a button

8' 6-Pin DIN cable for MPG-70, PG-200, PG-800 racks & hardware Each assign can control 5This is a 8' 6 PIN DIN cable for MPG 70. Please note that pin 2 of this connector is not connected, and is not going to work if used with a PG 300 or PG 800. The DIN cable is available in 2 configurations. If you are only using the cable to power an MPG 70, and you are using MIDI (not PG800 protocol) to communicate with the JX, then a "power only" DIN cable is available. This cable will only have +V and GROUND connected, which is all the MPG70 needs